This listing is for the large Hexagon cake stands only sold as a set in limited sizes and finishes.
See other listing for the smaller sizes.
The Hexagon frame comes suitable for a cake of the following width & heights -
50cm hex frame is suitable for a cake with a base tier of 28cm wide and height of 40cm.
60cm hex frame is suitable for a cake with a base tier of 32cm wide and height of 50cm
70cm hex frame is suitable for a cake with a base tier of 38cm wide and height of 60cm.
80cm hex frame is suitable for a cake with a base tier of 42cm wide and height of 70cm.
90cm hex frame is suitable for a cake with a base tier of 48cm wide and a height of 80cm.
The bases are approximately 5cm wider than the base of the frame.
The base is made from RECLAIMED RECYCLED 2.5cm thick timber planks not new wood. Therefore no two bases are the same.
Base finishes - please see base listing for close ups.
Base finishes.
Light Rustic - which is weathered and has a top coat varnish on the polished sides.
Dark Rustic - which has a dark waxed applied to the full stand and has a top coat varnish to the polished sides.
The wax can be reapplied to keep it dark look as it will lighten over time.
Black or White Wash - where the grain still shows through and has a top coat varnish to the polished sides.
Gold is the only metallic available as a base. It will show the grain of the wood through the finish - no top coat is applied.
PLEASE NOTE - They fit together by the hexagon sitting between the timber planks which are 2.5cm deep and a minimum of 4cm of the hex size will be used up by this. The planks will be slightly wider than the gap required (1cm) for the hoop so depending on the size of your cake bottom tier and if you are wrapping the hoop with decoration you may want to use sticky heavy duty pads to reduce the gap and cushion the hex as it will have some flexibility.
If you require the distance to be set and not allow any room for decorations or any particular cake size so please add any notes to the ‘note to seller at the cart’ about any specific requirements.
Please add a 'note to seller' if there's a particular look you are after.
PLEASE NOTE ----------The wood we use is recycled reclaimed timber which will have some dents and cracks which adds to its character. Should you wish for an alternative full metal cake stand please refer to another listing which is available.
We strive to make as many lovely accessories and props as possible and we hope you are satisfied with the product.
Our work is made from reclaimed timber and the unused or unseen back side of the wood is not restored and comes in its original condition. We strongly recommend you store the wooden base somewhere dry and flat as it is a natural product and can warp in changing temperatures. Each piece is hand worked and hand painted. Therefore some of the wood grain, knots, indentations, variance in colour will show through. These variations and simple imperfections are what make your wood sign unique as no two pieces are ever the same.
Thank you! x
❤️ Decoration not included - suitable for DIY use. HEXAGON CARE - Please be aware that the hoops may tarnish or could chip with over use (especially if used at Weddings every week) and the hexagon is made from steel and if left out in changing weather conditions or is exposed to water the iron will rust over time - HOWEVER the hexagons are sprayed with rustoleum spray (available in all the metallic colours used) so if you lightly sand the hoop you are able to re-spray the hoop again - a new coat of RUSTOLEUM will bring them back to life and you can continue to use the hexagons for a number of years ❤️