Go to Whiteys Wicked Workshop Patreon for monthly STL files https://www.patreon.com/WhiteysWickedWorkshop

Building a Millennium Falcon Cockpit? Well then you will need these Hyperdrive Levers to go into Ludicrous speed. :)

Here is a video of me explaining the Prop: https://youtu.be/GlcZ8nsjQHo

This set includes:
- (QTY4) Levers (attached to wooden dowels)
- (QTY4) 3/8" x 12" wooden dowels,
- (QTY12) 3mm, All Set screws needed (mounted, screwed in)
- (QTY4) Mount and Lever connection to attach to cockpit dashboard/face.
- (QTY 2) Yellow Stickers
- (QTY 2) Red Stickers
- (QTY 1) Extra Knurled piece ) = Extra's just
- (QTY 1) Extra bottom piece ) = in case

Each lever includes 9 Individual pieces, 1 wooden dowel, 3 set screws, 1 screw, 1 lock nut, and 2 washers.

NOT INCLUDED: Mounting bolts for dashboard and stops NOT INCLUDED (4mm X approx 11mm or the thickness of your dashboard) NOT INCLUDED
If I would have included these bolts the shipping would have doubled. These are easily available at a hardware store. Console also NOT INCLUDED

Dimensions:
-Lever assembly is approximately 4.25" x 1.24” wide at thickest part and smallest is .59”
-Dowel 3/8" x 12" but can be cut down
-can also replace dowel with 3/8" dowel aluminum (not included)

Assembly:
-Cut dowel to length needed (if necessary)
-Finish and paint
-Select positions and mark where the bottom will be mounted
-Mark the holes and drill holes in each lever base mount
-Mount the bottom piece to your dashboard top
-Screw each mount in place from underneath, using 4mm screws (not included),
-insert dowel into bottom mount
-tighten 1.5mm x 3mm set screw

PROTIP:
1. Paint - Make sure to let dry before handling.
2. Do not over tighten the screws
3. Use Rust-oleum Bright Coat Chrome